Random good picture Not show

1 The use of parallel processing in finite element analysis.

2 This is the power of the finite element method.

3 In this case the subject for the finite element analysis is the bone.

4 The finite element and dynamic stiffness methods are introduced and exemplified in simple cases.

5 This paper establishes the finite element equation for the spherical shell.

6 Strength of the school box with ABAQUS finite element analysis,(www.Sentencedict.com) and electric stress test method.

7 Finite element method is applied to solve the field with the temperature field characteristic, then the ampacity of buried cables is received after iterative computation.

8 Three-dimensional finite element model of Lijiaxia Hydropower Station is established to monitor operation condition of the arch dam.

9 That we use finite element analysis calculate to the strength and the rigidity of the bodywork structure. Thus the optimum fillet of the small underframe structure can be specified.

10 The 3D elastic-plastic finite element model for the stretch forming of automobile wheel hub end housing was established, and the deep drawing process was numerically simulated by MARC software.

11 In this paper, the relativity of 3D finite element meshes is discussed and an efficient hidden surface removal algorithm based on the relativity is presented.

12 Methods:The models of 3 dimensional finite element analysis (3 D FEA) of left upper permanent central incisor were designed by microtomy. Comparative studies of stress distribution were carried out.

13 Objective : To build a three - dimensional finite element model of temporomandibular joint and the mandible.

14 Methods A three-dimensional finite element model of the nasomaxillary complex was created, consisting of 1638 isoparametric elements and 1827 nodes.

15 In this paper, finite element method is used to the computation of the equivalent resistance network for multilevel packing structure with arbitrary boundary.

16 This paper proposes a load-modifying method for the finite element analysis of the single-deck floating roof under rainwater loading.

17 In this paper , Finite element analysis ( FEA ) simulation models for partial discharge wave propagation are built.

18 The shredding process of steel scrap was simulated through FEM software ANSYS/LS-DYNA based on Nolinear finite element method. The simulating results that steel scrap is shredded are acquired.

19 Objective:To conduct such a study on TSS downstream of mitral stenosis using a finite element model of two dimensions combined with Doppler echocardiography in human beings.

20 Head shaft is one of the main load- carrying parts in chain conveyor. Finite element analysis and optimal design of the head shaft are conducted and its optimum dimensions are obtained.

21 In this thesis, we analyze and design the piezoelectric device by finite element simulation.

22 The element size affects greatly the simulation result during finite element analysis of structure, in ANSYS.

23 The tube expanding process is simplified as the deforming process. of a ring under internal pressure. Aspecific finite element analysis procedure is programmed to simulate the deforming process.

24 In architectonics , the calculation of rectangular plate on elastic foundation, in common, is used by the finite element method and chart. It is difficult to obtain the universal analytic solution.

25 The study on dynamic characteristic of rolling washing machine cabinet is performed with Finite Element Analysis Method and modal experiment.

26 Aiming at flitch plate structures, a convenient and practical finite element model is built.

27 To make a better understanding of joint mechanics behaviors, this thesis studies joints of T-section steel truss with finite element method (FEM).

28 The convergence analysis for the second order hyperbolic equation with the P 1 - nonconforming finite element is discussed.

29 According to the structural feature of parallel single disk gate valve, the strength and rigidity of body will be calculated with finite element method, and with cylindroid shell theory.

30 The effect of elastic modulus of adhesive on the str ess distribution in aluminium alloy single lap joint was investigated using elastic-plastic finite element method(FEM).